H&K P30SK and VP9SK 9 mm Magazine Capacity Limiter

Return to Previous Page

H&K P30SK & VP9SK Magblock 10/13 (9mm)

Be the first to review this product

$6.59

Product code: HK P30SK/VP9SK_10/13(U-4.5)

Availability: In stock

Buy 3 for $6.30 each and save 4%
Buy 10 for $5.95 each and save 10%

Quick Overview:

Magblock 10 Round Limiter for Heckler & Koch P30SK and VP9SK 9mm

- Fits 13 round 9mm H&K P30SK and VP9SK magazines.
- Limits the magazine to 10 rounds of 9 mm
- Easy installation on top of the locking plate as shown in the photos.
- New, Improved design.
- Lightweight, efficient design.

NOTE: Multiple variations of this magazine may exist. Consider ordering the Universal Kit below or un-glued option below. With this you can easily trim the slide down if needed. Most need to be cut around 4-5. The Universal Limiter below also gives you the option to custom fit to your magazine and tension on the last round. Order the Universal at this link:
http://www.magazineblocks.com/magento/magblock-universal-pistol-limiter.html

FYI: This block is made from our Universal Pistol Limiter and is cut so that the number "4-5" shows up in the indicator notch. The lock tab is not used and the slide is cut so that it is flush with the base of the limiter. The 2 pieces are then bonded together. See photos for details.

Quantity:

Add to Cart

Details

H&K P30SK VP9SK 9mm Magblock (10 Round Limiter for 13 Round Magazines)

This Magblock fits the H&K P30SK and VP9SK 9mm magazines and will limit them to 10 rounds. New design easily installed in seconds on top of the magazine locking plate.

In the case of the H&K P30SK/ VP9SK line, it did not exist before 2000, when the California high capacity ban went into effect. Presuming that only H&K magazines fit H&K pistols, it would be impossible to own large-capacity P30 or VP9 magazines before January 1, 2000 -- because none had yet been manufactured. Claiming to have owned such before this law went into effect is not going to stand up. Make sure you only use 10 round magazines in H&K P30SK/VP9SK pistols since manufacture started in 2006.

- Simple install to make 10/13 H&K P30SK/VP9SK and VP9 magazines.
- Lightweight and will not interfere with magazine reliability.
- Made of heat resistant, reinforced polymer.