Steyr ATD Magblock 10 round Limiter for 18 Round Magazines

Return to Previous Page

Steyr ATD 10 round limiter for Mec-Gar 18 round 9mm magazines.

Easy to install at the base of the spring. Epoxy can be added here or the floor plate sealed closed for a permanent modification. So easy to install an idiot politician could do it.

This limiter installs as shown here. All original parts are used with no external modifications to the magazine or reliability.

STEYR ATD Magblock 10/18 (9mm)

Be the first to review this product

$6.69

Product code: Steyr_ATD_10_18(9mm)

Availability: In stock

Buy 3 for $6.39 each and save 4%
Buy 10 for $5.95 each and save 11%

Quick Overview:

Magblock 10 Round Limiter for Steyr ATD 18 Round Magazines

- Fits 18 round 9mm Steyr ATD magazines.
- Easy installation at the base of the spring.
- Limits the magazine to 10 rounds of 9mm.
- Held in place with spring tension or can be epoxied for a permanent modification.
- Lightweight, efficient design.
- Made of a super strong, heat resistant, fiber reinforced polymer.

*This Limiter can be made using the Universal Pistol Limiter by cutting flush at the base with #16 in the indicator notch.
*The product sold at this link is pre-cut and fixed at this length.

* This block will work in the Tisas Zigan 9mm Mecgar 18-round magazine.

*ATTENTION: This posting is for the Magblock (only) and not for the magazine. We don't currently sell any magazines at all.

*Select Desired Magazine Capacity

10 Round Limiter (10/18)
15 Round Limiter (15/18)

* Required Fields

$6.69

Quantity:

Add to Cart

Details

Steyr ATD Magblock 10 Round Limiter for 18 Round Magazines

This Magblock fits the Steyr ATD 18 round magazines and will limit them to 10 rounds. Easily installed in seconds at the base of the spring. It is held in place with spring tension alone or can be epoxied if desired.

- Simple install to make 10/18 or 15/18 Steyr ATD magazines.

- No modification to the magazine is required.

- Lightweight and will not interfere with magazine reliability.

*This Limiter can be made using the Universal Pistol Limiter by cutting flush at the base with #16 in the indicator notch.
*The product sold at this link is pre-cut and fixed at this length.