Springfield Hellcat 9mm 10/15 Magazine Capacity Limiter

Return to Previous Page

Hellcat Pro 10/15_Magblock 9mm - Block installs into the follower and held with spring tension.

Hellcat Pro 10/15_Magblock 9mm - For the 15 round Hellcat magazine, only.

Hellcat Pro 10/15 #4 Follower - If you have this follower in your Hellcat Pro magazine, then you will need the special cut Hellcat Pro Magblock

Hellcat Pro #3 follower - If your magazine comes with the #3 follower, then you'll need the special cut block.

Springfield Hellcat Pro 10/15 Magblock (9mm)

Be the first to review this product

$6.50

Product code: Hellcat Pro 10/15_Magblock 9mm

Availability: In stock

Buy 3 for $6.25 each and save 4%
Buy 10 for $5.95 each and save 8%

Quick Overview:

Springfield Hellcat 9mm 10/15 Magblock

- Fits 15 round 9mm Hellcat Compact magazines.
- Easy installation under the magazine follower.
- Limits the magazine to 10 rounds of 9mm.
- Held in place with spring tension or can be epoxied for a permanent modification.
- Lightweight, efficient design.

Note: Please verify which number is showing under the follower of your magazine. If the number reads #4 or #3 then you'll need a special cut Hellcat block. If it reads any other number, then you can use the standard cut block.

*Select Hellcat Pro Block

Standard Hellcat Pro Block
Special Cut Hellcat Pro Block

* Required Fields

$6.50

Quantity:

Add to Cart

Details

Springfield Hellcat 9mm 10/15 Magblock

This Magblock fits the New Springfield Hellcat 15 round 9mm magazines and will limit them to 10 rounds. Easily installed in seconds under the magazine follower. It is held in place with spring tension alone or can be glued or epoxied if desired.

-Simple install to make 10/15 Hellcat magazines.

-No modification to the magazine is required.

-Lightweight and will not interfere with magazine reliability.

-Will work in Hellcat Pro magazines.

Attention: Some Hellcat Pro magazines are coming with slightly different followers, and in turn will need our special cut Hellcat Pro block. If you have a #4 or #3 follower (the number under the follower) reads 4 or 3, then you will need the "special cut" magblock. If any other number is showing then you can use the standard cut block.