Search results for 'pmag magazines'

For use with Magpul Pmag Gen M3

Gen M3 Magpul PMAG Ranger Plate

This is a floorplate replacement for the 5.56x45 PMAG Gen M3 that incorporates an integral loop similar to the original Magpul USGI Ranger.

When installed on the base of a magazine, the PMAG Ranger Plate provides unsurpassed speed and control during high stress, tactical magazine changes.

Fits Gen M3 Pmags only in 10, 20, and 30 round sizes.

Gen M2 Magpul PMag 10/30 limiter 3 Pack Kit

Save time and money by making your magazines legal. 

- This Magblock fits the Gen2/M2 Magpul 30-round Pmags.

- Easily installs at the base of the spring. It is held in place with spring tension alone or can be epoxied if desired.

- No modification to the magazine is required.

- Lightweight and will not interfere with magazine reliability.

- Requires cutting of the Magblock for Gen2 20-round magazines.

-Magazines can be loaded with the bolt closed.

 

 

MagazineBlocks LLC locking plate for Magpul PMAG .223/ 5.56 magazines. Fits 10, 20, and 30 round Pmags. This is our brand locking plate since we are sold out of originals. Works the same. Choose Generation of your magazines below: Gen M3 will state this on the side. If you don’t see it then you have Gen 2 / /MOE pmags.

ProMag M14/M1A 7.62x51mm/.308 20 round magazines.

- Easiest and quickest way to make a 10 round M14 Promag (Only) Magazine.

- Can be permanently attached to the spring with epoxy.

- The block attaches to the spring to prevent noise and movement.

- No magazine modifications required.

-Allows loading on a closed bolt with 10 rounds installed.

-New light weight design.

-This block is designed for the PROMAG M14/M1A 20 Round magazine, only. Military surplus and other manufacturers use our standard block.

Magblock 15/30 MCL (Magazine Capacity Limiter) for Magpul 30 round Pmags in 300 Blackout only.

- This block will replace the lower spring attachment point  or locking plate and convert a 30 round magazine to hold only 15 rounds.

- The Pmag dust covers will still fit when loaded.

- Magazines can be loaded with the bolt closed.- Does not affect reliability.

- No increase in spring pressure.