Search results for 'hk g3 mags'

Taurus G3 Magblock 10/17 and 15/17 (9mm) 10 and 15 Round Limiter

This Magblock fits the factory Taurus G3 17 round 9mm magazines and will limit them to 10 rounds. Easily installed in seconds at the base of the magazine. It is held in place with spring tension alone or can be glued or epoxied if desired or required. This provides an easy method to convert your factory Taurus G3 magazines to 10 rounds. No external modification to the magazine is required

Has been tested on original factory magazines.

Magblock 10 Round Limiter for Act-Mag - Armscor Sig Sauer P320 17 Round Magazines

- Fits 17 round 9mm Act-Mag - Armscor Sig P320 magazines. 
- Easy installation at the base of the spring.
- Limits the magazine to 10 rounds of 9mm. 
- Held in place with spring tension or can be epoxied for a permanent modification. 
- Lightweight, efficient design. 
- Made of a super strong, heat resistant polymer.

*This block is designed for the Act-Mag - Armscor Sig P320 17-round magazines. This block won't work in factory Sig Sauer P320 magazines.

Works on G3 and HK91 twenty round magazines.

G3 and HK91 10/20 Block for 7.62x51mm or .308 magazines.

To Install:
This new design is held to the spring by removing the locking plate and installing the spring into the hole in the block as seen in the photo. The block and spring is then inserted back into the magazine. The locking plate is then positioned under the block. Then slide the floor plate closed as normal.

No external modifications to the magazine are necessary.