Search results for '5/20'

USGI .458 SOCOM Magblock 5/20 (5 Round Magazine Capacity Limiter)

- Fits USGI 20 round "Curved body" magazines made by C-Products and ACS when used with .458 SOCOM adapter. 
- This block will attach to the bottom of the spring.
- Will convert a 20 round (.223/5.56) magazine to hold only 5 rounds of .458 SOCOM.
- Magazines can be loaded with the bolt closed in most rifles. Fitting may be required in some cases.
- Does not affect reliability.
- No increase in spring pressure. 
ONLY FITS PICTURED MAGAZINES USED WITH FOLLOWER ADAPTER AND .458 SOCOM AMMUNITION.

USGI 350 Legend Magblock 5/20 (5 Round Magazine Capacity Limiter)

- Fits USGI 20 round magazines made by C-Products/Duramag. 
- This block will attach to the bottom of the spring.
- Will convert a 20 round (350 Legend) magazine to hold only 5 rounds.
- Magazines can be loaded with the bolt closed in most rifles. Fitting may be required in some cases.
- Does not affect reliability.
- No increase in spring pressure. 
-Installs at the base of the magazine.

SCAR 17 MAGBLOCK 5/20

- New and Improved Easy Install Design.  Makes removal after hunting season easier. 

- This block will fit original 7.62x51mm NATO/.308 SCAR 17 Magazines made by FNH.

- The block attaches to the bottom of the magazine spring and will convert 20 round magazines to hold only 5 rounds.

- No modifications to your expensive FN SCAR magazines are needed to install.

- The block can be secured to the spring for a permanent modification or removed to restore full 20 round capacity.

- For use where hunting laws restrict capacity to 5 rounds. 

Made from super strong ABS plastic.

*PATENT PENDING*

Lancer L7 5/20 Limiter for 20 round magazines in .308/7.62x51mm.

- This block will replace the lower spring attachment point  or locking plate and convert a 20 round magazine to hold only 5 rounds for hunting.
- Only fits L7 Advanced Warfighter with slide on base as shown.
- Does not affect reliability.
- No increase in spring pressure or wear. 
Note: This is a custom modified Pmag block and will replace the original base. 

Fits Browning BAR .30-06 20 round magazines.

- Easiest and quickest way to make a 5 round Browning BAR Magazine perfect for hunting.

- Can be permanently attached to the spring with epoxy.

- The block attaches to the spring to prevent noise and movement.

- No magazine modifications required.

-Allows loading on a closed bolt with 10 rounds installed.

-New light weight design.