Return to Previous Page
Details
Sig Sauer P228 Magblock 10 Round Limiter for 13 Round Magazines
This Magblock fits the Sig P228 13 round 9 mm magazines and will limit them to 10 rounds. Easily installed in seconds at the base of the spring. It is held in place with spring tension alone or can be epoxied if desired.
- Simple install to make 10/13 Sig Sauer P228 magazines.
- No modification to the magazine is required.
- Lightweight and will not interfere with magazine reliability.
- Tested on factory Sig P228 magazines as shown in the photos. The block may need to be modified to work with magazines from other manufactures if they are significantly different than the magazine pictured.
Additional Information
Custom design | No |
---|
Customer Reviews
- Review by Bruce
-
10/13 should be called 9/13. Install was super easy on original Sig Sauer magazine. Problem is magazine now only holds 9 rounds. all springs are seated flat in block and follower. I don't know if the spring is stopping the last round or if the top of block is too tall. Simple cure now requires time to fiddle...
Reply from MagazineBlocks:
We will be changing this over to the Universal limiter shortly. Some magazines do need a little fine tuning. Just an 1/8” sanded off the bottom can make all the difference. In a double stack magazine this will add twice as much room st the top. We can always send out a custom limiter size too if needed. Thank you. (Posted on 3/7/2019)