Sig Sauer P226 Magblock 10 round Limiter for 18 Round Magazines

Return to Previous Page

Sig P226 10 round limiter for Mec-Gar 18 round 9mm magazines.

Easy to install at the base of the spring. Epoxy can be added here or the floor plate sealed closed for a permanent modification. So easy to install an idiot politician could do it.

This limiter installs as shown here. All original parts are used with no external modifications to the magazine or reliability.

Sig Sauer P226 MecGar Magblock 10/18 (9mm)

Be the first to review this product

$6.59

Product code: Sig_P226_1018_9mm (U-16)

Availability: In stock

Buy 3 for $6.30 each and save 4%
Buy 10 for $5.95 each and save 10%

Quick Overview:

Magblock 10 Round Limiter for Sig P226 18 Round Magazines

- Fits 18 round 9mm Sig P226 magazines made by Mec-Gar.
- Easy installation at the base of the spring.
- Limits the magazine to 10 rounds of 9mm.
- Held in place with spring tension or can be epoxied for a permanent modification.
- Lightweight, efficient design.
- Made of a super strong, heat resistant, fiber reinforced polymer.

*This Limiter can be made using the Universal Pistol Limiter by cutting flush at the base with #16 in the indicator notch.
*The product sold at this link is pre-cut and fixed at this length.

* This block will work in the Tisas Zigan 9mm Mecgar 18-round magazine.

*Select Desired Magazine Capacity

10 Round Limiter (10/18)
15 Round Limiter (15/18)

* Required Fields

$6.59

Quantity:

Add to Cart

Details

Sig Sauer P226 MecGar Magblock 10 Round Limiter for 18 Round Magazines

This Magblock fits the Sig P226 18 round magazines made by Mec-Gar and will limit them to 10 rounds. Easily installed in seconds at the base of the spring. It is held in place with spring tension alone or can be epoxied if desired.

- Simple install to make 10/18 Sig Sauer P226 magazines.

- No modification to the magazine is required.

- Lightweight and will not interfere with magazine reliability.

- Tested on Sig P226 magazines made by Mec-Gar as shown in the photos. The block may need to be modified to work with magazines from other manufactures.

*This Limiter can be made using the Universal Pistol Limiter by cutting flush at the base with #16 in the indicator notch.
*The product sold at this link is pre-cut and fixed at this length.