H&K P30 and VP9 9 mm Magazine Capacity Limiter

Return to Previous Page

H&K P30 and VP9 Magazine Capacity Limiter for 9 mm 15 Round Magazines.

HK P30 Limiter works in factory 15 round 9 mm magazines. Installs on top of the lower locking plate as shown.

Sits on top of the original locking plate as shown.

Insert into the spring as shown, then reassemble using all the original parts.

Universal limiter cut down to show "9" in the notch. Bottom is flush with the base.

H&K P30 & VP9 Magblock 10/15 (9mm)

1 Review(s) | Add Your Review

$6.59

Product code: HK_P30_9mm_1015 (U-8.5)

Availability: In stock

Buy 3 for $6.30 each and save 4%
Buy 10 for $5.95 each and save 10%

Quick Overview:

Magblock 10 Round Limiter for Heckler & Koch P30 and VP9 9mm

- Fits 15 round 9mm H&K P30 and VP9 magazines.
- Limits the magazine to 10 rounds of 9 mm
- Easy installation on top of the locking plate as shown in the photos.
- New, Improved design.
- Lightweight, efficient design.

NOTE: Multiple variations of this magazine may exist. Consider ordering the Universal Kit below or un-glued option below. With this you can easily trim the slide down if needed. Most need to be cut around 8-9. The Universal Limiter below also gives you the option to custom fit to your magazine and tension on the last round. Order the Universal at this link:
http://www.magazineblocks.com/magento/magblock-universal-pistol-limiter.html

FYI: This block is made from our Universal Pistol Limiter and is cut so that the number "8-9" shows up in the indicator notch. The lock tab is not used and the slide is cut so that it is flush with the base of the limiter. The 2 pieces are then bonded together. See photos for details.

Quantity:

Add to Cart

Details

H&K P30 VP9 9mm Magblock (10 Round Limiter for 15 Round Magazines)

This Magblock fits the H&K P30 and VP9 9mm magazines and will limit them to 10 rounds. New design easily installed in seconds on top of the magazine locking plate.

In the case of the H&K P30 line, it did not exist before 2000, when the California high capacity ban went into effect. Presuming that only H&K magazines fit H&K pistols, it would be impossible to own large-capacity P30 or VP9 magazines before January 1, 2000 -- because none had yet been manufactured. Claiming to have owned such before this law went into effect is not going to stand up. Make sure you only use 10 round magazines in H&K P30 pistols since manufacture started in 2006.

- Simple install to make 10/15 H&K P30 and VP9 magazines.
- Lightweight and will not interfere with magazine reliability.
- Made of heat resistant, reinforced polymer.

Additional Information

Custom design	No

Customer Reviews

Review by Gore: Installed in a few minutes for 2 magazines. Pull the base plate off, put this block in and replace the base plate. Worked great after, tested with 500 rounds in two magazines. No problems at all. (Posted on 7/3/2018)